![]() ![]() These are very easy to install and offer optimum performance. #Osmos filter freePrecisely engineered, these Reverse Osmos Filters are quality checked on various parameters, before dispatch so as to offer clients only defect free range. If you changed the reverse osmosis membrane, drain the first tank of water and allow it to fill again before using the water. Made from high grade components, these Reverse Osmos Filters are highly durable and reliable. The pressure should be 7 - 8lbs.Īfter 10 minutes, open the water storage tank valve and allow the tank to fill for 2 hours before using it. After a few minutes, the tank will be empty.Ĭlose the water storage tank valve. Turn on the main water supply valve, it can be tested by unscrewing the blue cap from the side of the holding tank and checking the pressure using a Schrader (the same valve as car and bicycle tires) tire pressure gauge. ![]() This is so you can drain the water leftover from the storage tank so it will rinse the carbon dust from the new post filter. Once all water filters and the RO membrane have been replaced and housings have been tightened, before you turn the water back on, open the valve on top of the water storage tank and open the reverse osmosis faucet. Insert a new membrane, trim ¼” off the end of the tubing and reinsert it into the fitting. Remove the tubing from the membrane housing cap (the thicker end of the housing with only one tubing connection), unscrew the membrane housing cap, and pull out the old membrane, you may need to use needle nose pliers to get a good grip on it. ![]() If changing a reverse osmosis membrane, do it while the post filter is disconnected. Once all prefilters are replaced, remove the 10” inline post filter, it will either have a ⅜” push fit connection or ¼” female pipe threaded and included John Guest ¼” and ⅜” push fit connections by male pipe thread. (Changing filters one at a time will help avoid placing filters in the wrong position.) You will want to be near a sink or have a bucket to dump the water out of each housing as you remove it. When you tighten the water filter housings DO NOT over-tighten, you can crack the plastic or flatten an O-ring and cause your system to leak. Unscrew and remove each filter housing, one at a time, replace the water filter, and reinstall the filter housing using the wrench supplied with your system. Open the faucet to relieve the water pressure in the reverse osmosis system. Industrial Rerverse Osmosis Water Purifier (ROLTS-B), Find Details about Reverse Osmos Water Filter, Industrial Water Purifier from Industrial Rerverse. In order to replace your reverse osmosis filters, first close the main shutoff valve for your reverse osmosis system and close the blue handled valve on top of the water holding tank. #Osmos filter how toAlso: How To Sanitize Your Reverse Osmosis System The easy-to-follow steps below will help guide though replacing both for a standard reverse osmosis system. We suggest changing reverse osmosis filters in our ProSeries reverse osmosis systems yearly and replacing the RO membrane every 3 years. Changing Standard Reverse Osmosis Filters ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |